| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE BELT COVER.
|
| 2 |
|
REMOVE THE SCREW HOLDING THE BELT COVER TO REMOVE THE BELT COVER.
| Torx T25 |
|
|
| 3 |
|
LIFT THE RECOVERY TANK UP TO REMOVE IT FROM THE MACHINE.
|
| 4 |
|
PULL THE CHARGER PLUG ON THE BACK OF THE MACHINE TO DISCONNECT THE BATTERIES.
|
| 5 |
|
LOCATE THE RED AND BLACK WIRES CONNECTED TO THE CONNECTOR BLOCK. LOOSEN THE SCREWS AND PULL THE WIRES OUT OF THE BLOCK.
| Screwdriver-flat tip |
|
|
| 6 |
|
LOOSEN THE TOP BOLT ON THE BRUSH MOTOR TO CAUSE SLACK IN THE BELT SO IT IS EASY TO REMOVE FROM THE MOTOR PULLEY.
| Wrench-metric 10mm |
|
|
| 7 |
|
SLIDE THE BELT OFF THE BRUSH MOTOR PULLEY.
|
| 8 |
|
PULL THE BELT FROM THE BOTTOM BELT PULLEY AND IT IS NOW FREE FROM THE MACHINE.
|
| 9 |
|
REMOVE THE 3 BRUSH MOTOR BOLTS.
| Wrench-metric 10mm |
|
|
| 10 |
|
SLIDE THE BRUSH MOTOR BACK TO REMOVE THE BRUSH MOTOR PULLEY FROM THE BRACKET.
|
| 11 |
|
LIFT THE BRUSH MOTOR OUT OF THE MACHINE.
|
| 12 |
|
REVERSE STEPS 1 THRU 11 TO INSTALL A NEW BRUSH MOTOR AND TO REASSEMBLE THE MACHINE. MAKE SURE THE BELT IS PROPERLY TENSIONED AND ALIGNED WITH GROOVES ON PULLEYS.
|